H3c-technologies H3C WX5500E Series Access Controllers Instrukcja Użytkownika Pobierz pdf (Strona 44)

Configuring the information center

This chapter describes how to configure the information center.

Overview

The information center collects and classifies system information as follows:

• Receives system information including log, trap, and debugging information from source modules.

• Outputs the information to different information channels, according to output rules.

• Outputs information to different destinations, based on channel-to-destination associations.

Figure 17 Information center diagram

By default, the information center is enabled. It affects system performance to some degree when it is

processing large amounts of information. If the system resources are insufficient, disable the information

center to save resources.

Classification of system information

System information is divided into the following types:

• Log information—Describes user operations and interface state changes.

• Trap information—Describes device faults such as authentication and network failures.

• Debugging information—Displays device running status for troubleshooting.

Source modules refer to protocol modules, board drivers, and configuration modules which generate

system information. You can classify, filter, and output system information based on source modules. To

view the supported source modules, use info-center source ?.

System information levels

System information is classified into eight severity levels, from 0 through 7 in descending order. The

device outputs the system information with a severity level that is higher than or equal to the specified

level. For example, if you configure an output rule with a severity level of 6 (informational), information

that has a severity level from 0 to 6 is output.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 103 104

Brak uwag

H3c-technologies H3C WX5500E Series Access Controllers Instrukcja Użytkownika Strona 44