H3c-technologies H3C SecPath F5000-A5 Firewall Instrukcja Użytkownika Strona 79

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 78
69
To configure the exception handling method:
Ste
p
Command
Remarks
Enter system view. system-view N/A
Configure the exception handling
method for the MPU.
system-failure { maintain | reboot }
Optional.
By default, the MPU uses the reboot
method when an exception occurs.
NOTE:
Rebooting an MPU reboots the firewall.
Displaying the exception handling method
Use the display system-failure command to display the exception handling method.
<Sysname> display system-failure
System failure handling method: reboot
Rebooting your firewall
You can reboot the firewall in one of the following ways to recover from an error condition:
Reboot the firewall immediately at the command line interface (CLI).
At the CLI, schedule a reboot to occur at a specific time and date or after a delay.
Power off and then re-power on the firewall. This method, also known as hardware reboot or cold
reboot, might cause data loss, and is the least preferred method.
IMPORTANT:
Specify the boot file before you use the reboot command to reboot the firewall.
For data security, if you are performing file operations at the reboot time, the system does not reboot.
The precision of the rebooting timer is 1 minute. One minute before the rebooting time, the firewall
prompts "REBOOT IN ONE MINUTE" and reboots in one minute.
To reboot a firewall:
Task Command
Remarks
Reboot a card or the whole
system immediately.
reboot
Optional.
Available in user view.
Enable the scheduled reboot
function and specify a specific
reboot time and date.
schedule reboot at hh:mm [ date ]
Optional.
The scheduled reboot function is
disabled by default.
Available in user view.
Przeglądanie stron 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 120 121

Komentarze do niniejszej Instrukcji

Brak uwag