H3c-technologies H3C WX6000 Series Access Controllers Instrukcja Użytkownika Pobierz pdf (Strona 60)

Before using FTP, install the FTP client application on your PC. The FTP client software is not provided with

the WX6103 access controller. You must make sure that it is available by yourself. This section describes

how to maintain the access controller software using the FTP client application that comes with Microsoft

Windows XP.

Follow these steps to maintain the software of your access controller through FTP with the access

controller as the FTP server:

Step1 Set up a network environment, as shown in Figure 47:

Figure 47 Set up a software maintenance environment (AC as FTP server)

Step2 Configure the IP addresses for both sides, which must be on the same subnet. For example, set the IP

address of the FTP client to 192.168.0.1, and that of the access controller’s management Ethernet

interface to 192.168.0.2. Then use the ping command to verify the network connectivity.

Step3 Enable FTP service.

Configure FTP server authentication and authorization and enable FTP. The FTP server supports

multi-client access. When a remote FTP client sends a request to the FTP server, the FTP server executes an

action accordingly and returns the execution result to the client.

# Enable the FTP service.

[H3C]ftp server enable

# Add an authorized FTP username and password.

[H3C]local-user guest Create user account guest

[H3C-luser-guest]service-type ftp Set user type to FTP

[H3C-luser-guest]password simple 123456 Set password for user guest

Step4 Maintain the access controller.

After enabling the FTP service and configuring the username and password, start the FTP client

application on the PC.

# Open a DOS prompt window, and enter ftp at the DOS prompt.

C:\Documents and Settings\Administrator>ftp

ftp> The system prompt changed to ftp>

ftp> open 192.168.0.2 Connect to the access controller

Connected to 192.168.0.2.

220 FTP service ready.

User (192.168.0.2:(none)): guest Enter the username guest

331 Password required for guest

Password: Enter the password 123456

230 User logged in. Successfully connected to the server

Step5 Maintain the access controller software. Backup wx6103.bin on the access controller to the PC.

ftp> binary Set the transfer mode to binary

200 Type set to I.

ftp> lcd c:\temp Change the local path

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 89 90

Brak uwag

H3c-technologies H3C WX6000 Series Access Controllers Instrukcja Użytkownika Strona 60