H3c-technologies H3C WX6000 Series Access Controllers Instrukcja Użytkownika Pobierz pdf (Strona 35)

Step2 Connect the other end of the network cable to an RJ-45 port of the peer device.

Connecting optical fibers

Fiber connectors are indispensable passive components in optical fiber communication systems. Fiber

connectors make removable optical connections possible. This facilitates the testing and maintenance of

the optical system and enhances the system flexibility. Among diversified fiber connectors, the WX6103

access controller presently supports only LC type fiber connectors.

Figure 21 Appearance of an LC type fiber connector

NOTE:

• Before connectin

a fiber to your access controller, make sure that the fiber connector type a

rees with

the optical transceiver module.

• Before connectin

a fiber, make sure that the optical power does not exceed the upper limit of the optical

transceiver module’s receive power to prevent damage to the optical module.

Follow these steps to connect a pair of optical fibers:

Step1 Remove the protective cap from the optical interface to be connected, as shown in Figure 22.

Figure 22 Remove the protective cap

Step2 Align the end of the optical module without a handle with the SFP interface, making sure that the optical

transceiver module is not upside down, and insert the optical transceiver module into the SFP interface,

as shown in

Figure 23.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 89 90

Brak uwag

H3c-technologies H3C WX6000 Series Access Controllers Instrukcja Użytkownika Strona 35